Services
Development and testing services for solar-industry electronics
Five defined services covering the development and validation cycle of electronics for the solar industry, from PCBA to power optimizers. Every engagement starts with a scoped test plan and ends with formal technical documentation.
Technical Consultation for Prototype Development
Independent engineering input before the first hardware revision is committed. Circuit concepts, component selection and layout are reviewed for testability and reliability.
- Review of circuit design concepts and component selection for PV-specific stress profiles
- Design-for-test and design-for-reliability recommendations
- Definition of qualification criteria and test coverage for the prototype phase
Support for Laboratory and Field Testing Activities
Practical support for your own qualification campaigns in the laboratory or in the field, integrated with your internal procedures.
- Test plan development aligned with your internal qualification standards
- Instrumentation setup, data acquisition and measurement supervision
- Field test campaigns on operating PV installations
Technical Analysis, Measurement and Official Documentation
Precision measurement and root-cause analysis of PCBA behavior, concluded with official technical documentation.
- Electrical characterization: efficiency, thermal behavior, switching characteristics
- Failure analysis of returned or field-failed assemblies
- Formal test reports with documented setup, calibration references and raw data annex
Optimizer Performance & Reliability Testing under Variable Environmental Conditions
Systematic validation across the full environmental envelope optimizers face in the field, not only at nominal conditions.
- Temperature-dependent performance mapping across the specified operating range
- Load cycling and long-duration operation under realistic irradiance profiles
- Behavior under partial shading, rapid transients and grid-side disturbances
On-site Test Support at Client Facilities
Qualified test engineers with portable, calibrated instrumentation at your production site, development lab or installation.
- Commissioning measurements and acceptance testing at your facility
- On-site failure reproduction and diagnostic measurements
- Joint measurement campaigns with your R&D or quality team
Request a scoped test plan
Describe your test object, objective and timeline. We respond with a defined scope, method and quotation.